|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fiberglass 3/4" Door Rope (per foot)
|
Door rope gasket 3/4" for all gasification (Including Elite 100 and 200 models) & later model (late 2005 and after) conventional boiler doors. Either 9 feet or 11 feet needed. Please measure both fire door and ash door before ordering. It is recommended to replace both door gaskets every 3-5 years depending on use.
*Excludes some of the earlier models of the 250 and 450.
|
Door rope gasket 5/8" for 2005 or earlier 250 and 450 conventional boiler doors. 11 feet needed. Please measure both the fire door and ash door before ordering. It is recommended to replace both door gaskets every 3-5 years depending on use.
*Excludes later models of the 250 and 450.
If purchasing silicone gasket cement, 10oz is needed for 10 or more feet. Purchase here:
3 oz. tube of gasket cement. To purchase click here
10 oz. tube of gasket cement. To purchase click here
For the 250-450 Empyre and Cozeburn boilers, most came with 5/8" gasket in the firebox door and ashpan drawer. Both need to be replaced for maintenance and to avoid a potential boil over the situation from too much air entering the firebox.
After the introduction of gasification boilers, Pro-Fab started using the 3/4" gasket in all boilers.
For boilers built-in 2005 or earlier, we recommend 5/8" gasket. Most models need 11' for both doors. PLEASE MEASURE.
If you substitute 3/4" for 5/8" it will fit very tight in the groove of the door and ash pan. If a door is slightly warped, 3/4" is a better choice. If you wish to order 3/4" gasket, click here
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
WoodMaster 1" Fiberglass Firedoor Rope (priced by the foot).
The following Woodmaster models use this gasket. See the appropriate number of feet of gasket needed, based on your model.
3300 - 8 ft
4400 - 9 ft
5500 - 10 ft
6500 - 21 ft
This gasket is sold by the foot, to order 8' of gasket you need to put quantity 8
|
Fiberglass 1" Door Rope (per foot)
|
3/16" Key for Pelco Boilers. Fits models PC1020, PC1520 and PC2520
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Replacement Actuator Adapter for Stainless Manifolds
|
Fiberglass 1-1/4" Door Rope (per foot)
|
Bearing Flange for Pelco Boilers. Fits models PC1020 PC1520 and PC2520
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Replacement Red Lens for Water Level Light
|
Circuit Breaker / Switch, 10A 125VAC (Trimax M1101131)
|
Empyre / Cozeburn Wood Boiler: Hi temp silicone gasket cement for gasket, 3 fluid oz. tube. Safe for use up to 2000° F
Includes: A tube of 3 fluid oz hi temp gasket cement - recommended for 250 models
For a full parts breakdown of the Empyre and Cozeburn 250 models, CLICK HERE.
For a full parts breakdown of the Empyre and Cozeburn 450 models, CLICK HERE.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
100% Industrial Grade Silicone 10 OZ. Tube (Black) PN 0709-010
Used to seal door rope gasket on Woodmaster boilers.
|
WoodMaster replacement glass jar for outdoor night light. (PN 0020-777)
|
Splicer for 2' & 3' Hot Water Baseboard
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Reset Switch, Carling 110v
|
Switch, On / Off / Momentary, Carling 250v 10a (V751B10B-GJC00-000)
|
Replacement Fan Switch for Woodmaster stoves.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
AFS 1100 Replacement Jackshaft Bushing
|
Draft Spring
|
Black High Temp Silicone
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Thermistor Wire, AFS900 (30DSS-PTC-07 in-MF)
|
Baseboard Inside Corner
|
1/2" NPT Brass Thermowell w/set screw
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Replaces 0109-243(obsolete). Fits 3300,4400,5500,6500 and may look different than the original light.
|
Snap Disc Auto Reset (woodstove) 150 190
|
Start Run Harness - AFS900 (Steel & Composite)
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fire Pot Front End Plate
|
Replacement Light Switch for Woodmaster stoves.
|
Thermistor Wire for Digital Aquastat 9.85'
|
|
|
